Junger-audio D*AP8 Digital Audio Processor Manual de usuario descargar pdf (Pagina 17)

D*AP8

Setup GUI – SYSTEM – System Status

The system status is a special link you can reach independently from where you are :

The System Status page provides a top level view of the various status information available for the device.

Device Status provides the hardware status of the D*AP8 unit.

Power 1 status of the first power supply (left hand side from rear).

Power 2 status of second power supply (right hand side from rear).

Temperature measured on the surface of the main PCB.

Sync Lock turns red if the external sync source is removed or unstable.

Processing Status

Bypass turns red if Bypass is activated.

Interface Status

AES I/O turns red if an AES input that is internally in use (i.e. you have routed it to

an input of a function block) has detected an error.

Interface 1 SDI I/O turns red if the SDI input is not locked (not present or bad SDI signal).

Dolby Processing Status

Decoder turns orange if the input signal is not Dolby encoded (PCM).

Encoder A status of the first D-E encoder (if license is installed).

Encoder B1 status of the first D-D/D-D+/AAC encoder (if optional CAT561 is installed).

status of the D-E encoder (if optional CAT569 is installed).

Encoder B2 status of the second D-D/D-D+/AAC encoder (if optional CAT561 is

installed).

Metadata status of the metadata.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 99 100

Sin comentarios

Junger-audio D*AP8 Digital Audio Processor Manual de usuario Pagina 17