Junger-audio T*AP Television Audio Processor Edition Manual de usuario descargar pdf (Pagina 21)

T*AP

setup GUI – SYSTEM – System Status

The System Status page provides a top level view of the various status information available for the device.

Device Status provides the hardware status of the Base Unit

Power 1 status of the first power supply (left hand side from rear)

Power 2 status of second power supply (right hand side from rear)

Temperature measured on the surface of the main PCB

Sync Lock turns red if the external sync source is removed or unstable

Processing Status

Bypass turns red if Bypass is activated

Upmix turns green if Upmix is activated

Interface Status

AES I/O turns red if an AES input that is internally in use (i.e you have routed it to

an input of a function block) has detected an error

SDI I/O Interface turns red if the SDI input is not locked (no or bad SDI signal)

Dolby Processing Status

Metadata turns red if Metadata are not valid

Decoder turns red if the input signal is not Dolby encoded (PCM or corrupted)

Encoder 1 status of the first encoder (if optional CAT561 is installed)

status of the D-E encoder (if optional CAT569 is installed)

Encoder 2 status of the second encoder (if optional CAT561 is installed)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 67 68

Sin comentarios

Junger-audio T*AP Television Audio Processor Edition Manual de usuario Pagina 21