Junger-audio T*AP Television Audio Processor Edition Manual de usuario descargar pdf (Pagina 31)

T*AP

set up GUI – INTERFACES – (SDI I/O Interface) Status

This pan shows the status of the SDI interface (if one is installed) :

Video Standard display of the video standard detected by the SDI input.

SDI Bypass turns yellow if the SDI bypass function is activated.

Relay Bypass turns yellow if the power fail relay is deactivated manually.

Test Generator Active turns yellow if the Generator is turned on.

Video Delay Enabled turns green if the video delay is activated.

VANC Metadata turns green if Dolby metadata is present in the input SDI stream.

De-Embedder

VANC Metadata turns green if VANC embedder is enabled

Embedder

De-Embedder Audio Status is grey if no audio is present

turns green if PCM audio is embedded

turns yellow if a non audio signal is present, an additional label shows

the kind of signal if it is possible to gather the information.

De-Embedder VANC shows which SDID was found and gives the operator an indication

Metadata which audio signals are related to that SDID.

See SMPTE 2020 for details.

ARIB B39 meta information standard

Data Available turns green if ARIB B-39 meta information are detected

Block Error turns red if an error has been detected

Audio Mode see ARIB Japanese standard "Structure of Inter-Stationary Control

Data Conveyed by Ancillary Data Packets"

http://www.arib.or.jp/english/html/overview/doc/2-STD-B39v1_2.pdf

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 67 68

Sin comentarios

Junger-audio T*AP Television Audio Processor Edition Manual de usuario Pagina 31