Junger-audio D*AP LM2 / D*AP LM4 - Digital Audio Processor Manual de usuario descargar pdf (Pagina 38)

D*AP LM 4

Web GUI – AUDIO PROCESSOR – Output

Output – The final screen in this section allows for the adjustment of numerous audio parameters directly on

the final output signal.

Link [enable / disable]

Output [enable / disable]

Mute [on / off]

Attenuation (dB) [-80.0 … 0.0]

Mono [Stereo, L+R, LL, RR]

Output Delay (ms) [0 … 2.000]

Web GUI – EVENTS – Trigger – Trigger Configuration

EVENTS - In a broadcast facility, there are often requirements to integrate the Digital Audio Processor into

the automation system in order to facilitate functions such as remotely re-calling presets, firing GPO

commands etc. The events tab is where all relevant parameters can be set up.

A Trigger is the logical combination of up to two trigger sources. The Trigger may launch one or more

events. An event runs like a flip-book inside the D*AP. This powerful technology spans from simply recalling a

certain parameter to the complete reconfiguration of the LM 4. But it also enables several fail over scenarios

where the LM 4 will automatically react to the system and/or parameter status

Trigger – As a default, 8 standard trigger conditions are available. These can be configured to determine

actions resulting from combinations of hotkey, GPI, network commands, parameter values, active events,

other active trigger etc. stimulus :

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 55 56

Sin comentarios

Junger-audio D*AP LM2 / D*AP LM4 - Digital Audio Processor Manual de usuario Pagina 38