Junger-audio D*AP8 Digital Audio Processor Manual de usuario descargar pdf (Pagina 30)

D*AP8

You must use the scroll bar to navigate through the matrix. In the upper left corner you can select between

the ONAIR and the PRESETS view of the matrix.

On the ON AIR page you will also see the device signal labels (see ROUTING section further below for

details).

Channel Linking [mono / stereo]

You can decide if the routing must be performed in mono or stereo mode

(where adjacent odd/even channels are routed at once).

You may select cross points by hovering with the mouse over the little squares and select / deselect cross

points with a left mouse button click. A trace that symbolizes the signal flow is shown.

The color of the respective squares changes:

Mouse over Color codes of cross points:

dark blue Possible new cross point.

orange You are about to reconnect a cross point.

grey Cross point is not allowed (i.e. routing will cause a loop and will not

therefore be performed) or dedicated input is not activated.

red You are about to disable a cross point

An animated signal flow will help you when navigating through the matrix.

Setup GUI – INTERFACES – SDI I/O interface – Setup

SDI Bypass

SDI Relay Bypass Will deactivate the Bypass

Relay. It provides a shortcut from

SDI-IN to SDI-OUT1 and

disconnects the de-embedder

from the SDI input. This relay

also serves as a fail bypass if

the power is off. This feature

maintains the SDI signal for

downstream equipment.

SDI Embedder Will pass the embedded audio

Bypass data from the de-embedder to the

embedder 1:1. This function

preserves the original

Ancillary Data structure.

Video Delay

Video Delay [0 … 15]

(frames) For compensation of any kind of

audio processing delay within the

chain of devices you may use a

Video Delay. Position “0” turns

off the delay function.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 99 100

Sin comentarios

Junger-audio D*AP8 Digital Audio Processor Manual de usuario Pagina 30