Junger-audio D*AP8 Digital Audio Processor Manual de usuario descargar pdf (Pagina 40)

D*AP8

Mode [Switched / Redundant]

Redundant – The interface will duplicate the audio traffic to both

Ethernet ports. Both ports must have different

IP addresses

Switched – The second port behaves like an Ethernet switch

port allowing daisy-chaining through the interface.

I.e. IP configuration of the second port is only

available for redundant mode.

Important Note! When set to switched mode, do not connect both ports to the same network

(same Ethernet switch) if it does not support STP (Spanning Tree Protocol). This is the case for most of

the off-the-shelf (office) switches. Doing so will cause a race condition where IP packets are circling around

from the external switch to the second Dante (switch) port and back via the first port. This will tear down

your network and may create a bunch of new "friends" in your facility.

Primary Address Setup Setup of the primary network interface

Network Status [Offline / Connected + bandwidth]

DHCP – Automatic IP Config. [OFF / ON]

IP-Address

Netmask

DNS Server

Gateway

MAC Address

Secondary Address Setup Setup of the secondary network interface

Network Status [Offline / Connected + bandwidth]

DHCP – Automatic IP Config. [OFF / ON]

IP-Address

Netmask

DNS Server

Gateway

MAC Address [unknown / address]

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 99 100

Sin comentarios

Junger-audio D*AP8 Digital Audio Processor Manual de usuario Pagina 40