Junger-audio D*AP8 Digital Audio Processor Manual de usuario descargar pdf (Pagina 63)

D*AP8

Dual Mono [OFF / AUTO]

A detector looks for the input signal. If it is a left [L] or right [R] only it

converts that signal either to [L/L] or [R/R].

Fail Threshold (dBFS) [-80 … -40]

RMS weighted input level for fail detection

Fail Wait (s) [1.5 … 10.0]

elapsed time after fail detection until the switch over will happen

Fail Return (s) [0.0 … 10.0]

elapsed time after detection of a proper input signal until the switch

back to the program input

Side Chain Filter [OFF / ON]

a high pass filter (300Hz) and a low pass filter (3000Hz) is applied to

the detector side chain (not the audio path) to prevent hum and noise

from blocking fail over switching.

Setup GUI – AUDIO PROCESSOR – Filter – Spectral Signature

Spectral Signature is a highly sophisticated dynamic multiband filter to boost (or reduce) spectral parts

of the processed audio signal dynamically. It punches through a reference spectrum to the processed

audio signal.

Program / Section [Program1 / Program2 / Preset]

Selects the program for which Spectral Signature will be displayed.

Since this view does not allow the display of a preset page side by side

as usual one must select "Preset" to get to the preset editor.

Channel [1L/1R, 2L/2R, 1L, 1R, 2L, 2R]

Depending on the program selected and the link status (see below

lower graph) the channel under control will be displayed here.

Enable [ON / OFF]

Enables / disables Spectral Signature for the selected program.

Please note: For convenient operation, this function is also available

(in the Expert section, see below) within the web interface.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 99 100

Sin comentarios

Junger-audio D*AP8 Digital Audio Processor Manual de usuario Pagina 63